DFRduino Ethernet Shield V3.0 - W5100S (Support Mega and Micro SD) Shipping:2-4 Weeks PWM can be applied to

PWM can be applied to this pin (typically done with ENB low and either PWM1 or PWM2 high)

The TMF8801 outputs data through an I2C fast-mode communications interface and an integrated micro controller

The size and pinout has changed

Optimized 32

The Gravity interface is directly compatible with DFRobot Gravity sensors and modules

DFRduino Ethernet Shield V3.0 - W5100S (Support Mega and Micro SD) Shipping:2-4 Weeks PWM can be applied toUse this DFRduino Ethernet W5100S Shield to connect your Arduino to the Internet with a RJ45 cable. Plug the shield onto the board, burn the Ethernet sample codes into the controller, then an easy IoT project with stable communication is done. Based on WizNet WS5100S Ethernet chip, this board integrates full hardwired TCP IP protocol stacks and has 4 independent hardware SOCKETs. Your Arduino board can communicate with WS5100S and SD card through the